Vogelzang TR008 User Manual download pdf (Page 5)

TR008-96 | 20120425.0 www.vogelzang.com DURANGO™ | Page 5

ASSEMBLY INSTRUCTIONS

tools

TOOLS AND MATERIALS REQUIRED FOR INSTALLATION



 

 

 

 

 

 

 

 

materials

(NOTE: The following items are NOT included with your stove)

Flooring Protection: 29˝ x 48˝ as speciﬁed (see page 4)







Chimney: Existing 6˝ Lined Masonry Chimney or 6˝ Inside Dia.

Listed Type HT chimney.

Furnace Cement (manufacturer recommends Rutland Code 78



CAUTION: STOVE IS HEAVY. MAKE SURE YOU

HAVE ADEQUATE HELP AND USE PROPER

LIFTING TECHNIQUES WHENEVER MOVING

STOVE.

 

parts list shown on pages 18 & 19.

1. Uncrate the stove and remove cardboard packing

and protective poly bag. Remove bottom heat shield

(#16) from carton. (Save cardboard for further as-

sembly.)

     

material from inside stove pipe opening (Fig. 1).

This blanket provides an air seal on the side walls

of the stove to direct combustion gasses over the

secondary combustion tubes before exiting via the

chimney. 

or your stove will not operate properly.

2. Remove parts from inside stove. Parts include:

Blower Assembly (#F-6), Legs (#5) and Hardware

Pack (#08-HP) located inside ﬁrebox.

NOTE: Stove body is HEAVY. Make sure you have

adequate help to lift stove body and use proper

lifting techniques. Stove may be lightened during

installation by removing ﬁre brick. Replace ﬁrebrick

before using. There are ﬁve different sizes of brick.

Note the location of each while removing or refer

to ﬁgure 6 for proper location inside ﬁrebox.

3. Place ﬂattened carton on ﬂoor to protect stove ﬁnish

and lay stove onto it’s side.

4. Remove the hex nuts (#28) from the leg mounting

studs on the four corners of the bottom of the stove.

5. Position the bottom heat shield, ﬁgure 2, aligning

the corner holes with the four leg mounting studs.

The smaller cutout must align with the air intake in

NOTICE: Vogelzang International Corp. grants no warranty, stated or implied, for the installation or maintenance of your wood

stove and assumes no responsibility of any incidental or consequential damages.

Fig. 2 – LEG ASSEMBLY

Bottom Heat Shield and Leg assembly

the bottom front of stove. NOTE: The stove MUST



in place.

6. Align each leg with the mounting stud and slide into

place. Replace the leg mounting hardware (hex nut,

ﬁg. 2) after installing the leg. After all four legs have

been installed, tighten all mounting hardware.

7. Return the stove to the upright position.

8. Attach the back heat shield assembly (#2) to the

rear of the stove. The closed end is positioned to

the bottom of the stove with the open end up, ﬁg. 3.

Secure the back heat shield with four Phillips head

machine screws using the threaded holes located

Continued on next page

Figure 1 – DO NOT remove ceramic blanket from

inside stove pipe opening. This is NOT packing

material but an integral component of the stove

combustion system.

DO NOT

REMOVE!

1 2 3 4 5 6 7 8 9 10 ... 23 24

Comments to this Manuals

No comments

Vogelzang TR008 User Manual Page 5

Comments to this Manuals

Related products and manuals for Kiln Vogelzang TR008