Vogelzang VG820E (new as of 2013) User Manual download pdf (Page 2)

TOOLS AND MATERIAL NEEDED NOTES

TOOLS

Pencil

6 Foot Folding rule or tape

Tin Snips

Drill, hand or electric

Drill bit, 1/8" dia.

(for sheet metal screws)

Gloves

Screwdriver (blade-type)

5/16" Nut Driver or

5/16" Socket w/Ratchet

ELECTRICAL

120 Volts

60 Hertz

0.55 Amps

MATERIALS

Chimney Connection- 6" Dia. Black

Steel (24 Ga. minimum): Straight or

corrugated elbow (as required)*

1/2" Sheet Metal Screws

6" Inside Diameter Underwriters

Laboratories (UL) listed Residential

Type and Building Heating Appliance

Chimney, Type "HT", or 6" existing

Masonry Chimney with  ue liner.

Floor Protector Material: 3' x 4'-6" as

speci ed on page 4.

Furnace Cement (Manufacturer

recommends: Rutland Code 78 or

Equivalent)

* Avoid adjustable elbows, they leak!

CIRCULATOR DIMENSIONS

Fig. 1

32 1/4

12 1/2

33 1/2

4 1/8

4 1/4

19 1/4

CENTER LINE OF 6"

CHIMNEY CONNECTOR

TOP OF FLOOR PROTECTOR

CENTER LINE

OF 6"

CHIMNEY

CONNECTOR

RULES FOR SAFE INSTALLATION AND OPERATION

Please read this entire manual before you install and use your new room heater. Failure to

follow instructions may result in property damage, bodily injury, or even death.

SAFETY NOTICE: If this heater is not properly installed, a house  re may result. For your safety, follow the

installation directions. Contact local building or  re o cials about restrictions and installation inspection

requirements in your area.

1. Check local codes.  e installation must

comply with their rulings. Do not install this

heater in a mobile home or trailer.

2. Always connect this heater to a chimney or vent

to the outside. Never vent to another room or

inside a building.

3. Do not connect a WOOD burning heater

to an aluminum Type B gas vent.  i s i s n o t

safe and is prohibited by all codes.  is heater

requires connection to approved

chimneys:

Either a factory built 6" UL 103HT

or a lined and ap-

proved and recently inspected and cleaned masonry

chimney with a 6"  ue, preferably round. A larger

masonry  ue may be used, so long as the  ue-section

diameter is not greater than 50 sq. in.  e chimney

portion (whether factory-built, or masonry) must

be tall enough to provide su cient dra and safe

exit of smoke and combustion products.

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Vogelzang VG820E (new as of 2013) User Manual Page 2

Comments to this Manuals

Related products and manuals for Kiln Vogelzang VG820E (new as of 2013)